Filter
Top Products
REAR CROSS CHANNEL ADJUSTMENT
Slide the dishwasher into the cabinet opening, being careful to avoid damage to the floor or interference with water,
drain, and electrical lines. DO NOT remove the rear cross channel, unless there is an interference with the plumbing
lines. In most cases, any plumbing interference can be eliminated by raising one side of the rear cross channel. (See
Fig. 10 for details.)
Back of dlshwasher
Rear cross channel
I” alternate pos~llon
SteD
SleD
Looser
lhls SC’YW _
Remove
lhls screw. _
Line up the lower cross
channel hole with ihe
upper hole in frame
Fasten securely Tighten
.screw at other end.
- Step 1 ~ Remove
these screw’
cross channel
lglnal posltlon
the
s.
Fig. 10a
Unlatch and open the door and remove the foam shipping cushions from uppelr corners of the door. Check
to ensure that cabinet clearance is equal on both sides of the dishwasher and that cabinet interference does
not distort dishwasher tank.
With the door still open, place a spirit/bubble level against the front tank flange (Fig. 11) and level the dishwasher
front-to-back
and side-to-side by adjusting the leveling legs (Fig. 12) In or out as necessary.
Adjustable bracket in
shlpolng posltlon
>
Fig. 11
If the dishwasher is not properly leveled or if it is distorted by cabinet interference, the door may not seal properly
and may leak. If necessary, the leveling leg may be further adjusted to correct any distortion and align tank for
equal clearance on both sides (Fig. 12).
-9-