Filter
Top Products
BEFORE STARTING:
Please read these rnstallation instructions COMPLETELY AND CAREFULLY. They will save you time, work, and
help to ensure optimum dishwasher performance. OBSERVE ALL LISTED WARNINGS AND CAUTIONS.
For Replacement Installation - Review these complete instructions to be sure that previous connections are
compatible.
For New Installations - Plumbrng and electrical connections must be provided before the dishwasher is moved
Into place.
These instructions are intended for use by qualified workers who will observe all local codes and ordinances for
plumbing connections as well as local codes and/or the Canadian Electrical Code for’electrical connections.
DO NOT REMOVE THE GALVANIZED STEEL SIDE AND BOTTOM PANELS. THE REMOVAL OF
THESE ITEMS WILL VOID THE C.S.A. CERTIFICATION AND INCREASE THE DANGER OF FIRE AND
ELECTRICAL SHOCK.
I
YOU WILL NEED THESE TOOLS:
Phillrps Screwdriver
Flat Blade Screwdnver
Adjustable Wrenches (2) (if copper fittings are used)
Pipe Wrenches (2) (if galvanized or iron fittings are used)
Nut Driver or Socket Set
Wrre Cutters
Tape Measure
Spirit/Bubble Lever
Electrrc Drrll
1” (25 mm) Drill BII or Hole Saw
58 (3 mm) Drill Bit
Square
. . .
AA/D THESE MATERIALS:
5/a” (16 mm) OD Copper Tubing (of sufficient length for your installation), Shut-off Valve, and Fittings (for copper
water supply line)
l/i” (13 mm) Pipe (of sufficient length for your installation), Shut-off Valve, and Fittings (for galvanized water
supply line)
%I” (9.5 mm) NPT 90° Street Elbow
90° Compression Elbow: l/z” (13 mm) Tube End & 3/e” (9.5 mm) NPT male pipe end (for copper water supply
line only) See Fig. 13 page 10.
l/2” (13 mm) NPT 90° Street Elbow and
l/2”
(13 mm) NPT female x 3/a” (9.5 mm) NPT male reducing adapter
(for galvanized water supply line only)
9/,6” (14 mm) ID Heat and Detergent Resistant Rubber Hose and Clamps or s/a” (16 mm) OD Copper Tubing
and Fittings (of sufficient length to accommodate your drain line)
10” (250 mm) Length of 518” (16 mm) OD Soft Copper Tubing, Formed Into a Semicircle (if high loop drain
is required - see page 7)
115 Volt, 15 Amp, 2 Wire, Properly Grounded, Branch Circuit
x/4” (19 mm) Strain Relief Bushing for Electrical Supply Cable.
-3-