KitchenAid Mixer Mixer User Manual


 
Assembling Your Bowl-Lift Stand Mixer
Pre-Use Cleaning
Before using your Stand Mixer for the first
time, wash the mixing bowl and accessories
(see "Care and Cleaning" on page 14).
Attaching Mixing Bowl
1. Be sure speed control is OFFand mixer
is unplugged.
2. Placebowl lift handle in down position.
3. Fit bowl supports over locating pins.
4. Pressdown on back of bowl until
bowl pin snaps into spring latch.
5. Raisebowl before mixing.
6. Plug mixer in proper electrical outlet
(see page 4).
Removing Mixing Bowl
1. Be sure speed control is OFFand mixer
is unplugged.
2. Placebowl lift handle in down
position.
3. Remove flat beater, Wire Whip*, or
Dough Hook*.
4. Grasp bowl handle and lift straight up
and off locating pins.
Raising Mixing Bowl
1. Rotate handle to straight-up position.
2. Bowl must always be in raised, locked
position when mixing.
Lowering Mixing Bowl
1. Rotate handle back and down.
Injury Hazard
Unplug mixer before touching
beaters.
Failure to do so can result in
broken bones, cuts or bruises.
Attaching Flat Beater, Wire Whip*, or
Dough Hook*
1. Turn speed control to OFFand unplug.
2. Slip flat beater on beater shaft and
press upward as far as possible.
3. Turn beater to
right, hooking
beater over the
pin on shaft.
4. Plug mixer in
proper electrical outlet (Seepage 4).
Removing Flat Beater, Wire Whip*, or
Dough Hook*
1. Turn speed control to OFFand unplug.
2. Pressbeater upward as far as possible
and turn left.
3. Pull beater from beater shaft.
4. Plug mixer in proper electrical outlet
(See page 4).
Household Stand Mixer
Speed Control
Plug mixer in proper electrical outlet
(See page 4). Speed control lever should
always to be set on lowest speed for
starting, then gradually moved to
desired higher speed to avoid splashing
ingredients out of bowl. See page 10 for
Speed Control Guide.
Overload Reset Button
: Model KSMC50 Only
If the mixer is overloaded,
the Overload Reset Button
will pop out and the mixer
will shut off. Turn the Speed
Control Lever to OFRWait a few minutes,
then push in the Reset Button. Turn the
Speed Control Lever to the desired speed
and continue mixing.
* Sold separately for model K4SS,