KitchenAid Ventilation Hood Ventilation Hood User Manual


 
Install Filters
1. For recirculating installations only, install the charcoal filters
included in Recirculation Kit Part Number 4396565. Place the
charcoal filter against the blower cover and rotate to the right
(clockwise) to attach to cover. Repeat with other charcoal filter.
2. Replace metal filter. Place back edge of metal filter into
channel at rear of hood. Push filter up while pushing tab back.
When filter is in place, release tab. Locking pin will hold filter
in place.
Check Operation
1. Check operation of the range hood by turning on the power.
2. The range hood controls are located in front on the underside
of the range hood.
3. Move the light switch to “1” position. The light should turn on.
4. Move blower switch to “1” position. The blower should
operate.
5. Move the blower speed switch to “1” position for low speed,
“2” position for medium speed or “3” position for high speed.
6. Move blower and light switches to “0” position to turn blower
and light off.
7. If the range hood does not operate, check to see whether a
circuit breaker has tripped or a house fuse has blown.
Disconnect power supply and check that the wiring is correct.
NOTE: To get the most efficient use from your new range hood,
read the “Range Hood Use” section.
9
Optional Interchangeable Front Trim Installation
This hood comes standard with an Architect
®
Series II stainless
steel front trim piece. To replace the standard front trim piece with
an optional purchased front trim piece:
1. Reach inside the front of the hood and locate a hex nut
approximately 3" (7.6 cm) in from both outside edges.
2. Remove the 7 mm hex nuts.
3. Pull the trim piece straight out.
4. Insert the studs on the back of the new trim piece through the
holes in the front of the hood.
5. Replace the hex nuts and tighten securely.
A. Hood
B. Hex nut
C. Trim piece
A
B
C
A. Controls
B. Filters
A
B
A. Filter
A
INTERCHANGEABLE FRONT TRIM
Architect
®
Series - 30 Trim Kit
Stainless Steel
White
Black
Biscuit
Architect
®
Series II - 30 Trim Kit
White
Black
Biscuit
Pro Line
®
Series - 30 Trim Kit
Stainless Steel
Meteorite
Architect
®
Series - 36 Trim Kit
Stainless Steel
White
Black
Biscuit
Architect
®
Series II - 36 Trim Kit
White
Black
Biscuit
Pro Line
®
Series - 36 Trim Kit
Stainless Steel
Meteorite
PART NO.
8212621
8212462
8212463
8212461
8212623
8212624
8212622
8212464
8212465
8212625
8212467
8212468
8212466
8212627
8212628
8212626
8212469
8212470