Filter
Top Products
11
7. Measure the thickness of the cabinet floor, including the filler
strips, if used. If the thickness is less than ⁵⁄₈" (15.9 mm),
install wood filler strips that are a minimum length of
5" (12.7 cm) onto the cabinet floor. The mounting bracket
adjusts from ⁵⁄₈" (15.9 mm) to 2¹⁄₈" (54.0 mm) for the wood
filler strips.
8. The spring loaded brackets are factory set to accommodate a
thickness between 1³⁄₁₆" (3.0 cm) and 2¼" (5.7 cm). If your
cabinet bottom is less than 1³⁄₁₆" (3.0 cm) thick, the spring
loaded brackets can be removed and repositioned down from
the top setting (A), to the bottom setting (B), by removing the
4 Phillips screws.
9. Place the round damper into the vent opening of the range
hood and press down. If the roof cap or wall cap has a
damper, do not attach the damper to the range hood.
10. Place the range hood on its back side on a covered surface.
a) Slide the range hood screen forward.
b) Remove the metal grease filters. See “Range Hood Care”
section.
11. Screw the mounting brackets up to the top position
NOTE: For some non-vented (recirculating) installations it
may be easier to attach the vent system to the range hood
before lifting the range hood into its final location. Seal the
connection with clamps.
Install Range Hood
1. Using 2 or more people, lift the range hood into its final
position. (The wiring and terminal box are to be on top of the
range hood.)
2. Check that the mounting brackets overlap the cabinet bottom
or wood filler strips.
3. Center the range hood.
A.Less than ⁵⁄₈" (15.9 mm)
B.Wood fillers (thickness as required)
A.Top setting - factory installed
B.Bottom setting
A.Damper
B.Range hood screen
B
A
A
A
B
B
A
B
A
B
A
B
A.Mounting bracket screw
B.Flat-blade screwdriver
A.Mounting bracket
B.Optional wood filler strip
C.Cabinet bottom
D.Optional wood filler strip for recessed cabinet
E.Slide-out range hood
A
B
WARNING
Excessive Weight Hazard
Use two or more people to move and install
range hood.
Failure to do so can result in back or other injury.
A
B
C
D
E