Filter
Top Products
English
8
English
9
n Rinse the pour spout between uses for optimal results. Handwash with
warm soapy water. Do not wash in dishwasher - fig. 21.
n To remove, unscrew turning counterclockwise from main unit. To re-attach,
simply screw back in place turning clockwise.
n You should never attempt to access internal parts of the appliance.
IMPORTANT: After cleaning, ensure all parts of your BeerTender
®
have
completely dried before closing the lid.
STORING THE BEERTENDER
®
n When the BeerTender
®
is not being used for a long period of time, remove
the DraughtKeg
TM
and turn the control to “off”.
n Remove the plug from the power outlet.
n Store the BeerTender
®
at room temperature in a dry place out of children’s
reach.
n Protect from dust and dirt.
TROUBLESHOOTING
Problem Possible causes Remedies
The appliance does not
come on.
The appliance is not
connected to the outlet.
Connect the appliance
to the outlet.
You cannot position the
tap cover correctly.
You may have opened
the draught beer tube
(white plastic part at
the end of the serving
tube) by hand. If so, the
tap cover will not close
correctly and there is
a risk for the beer to
flow out.
Before installing the
draught beer tube
onto the BeerTender
®
tapping mechanism,
make sure that the
draught beer tube is
closed.
The DraughtKeg
TM
tap
or tube is not inserted
correctly.
If the draught beer
tube is not installed
properly in the tapping
mechanism or if the
tube is pinched, this
will affect the beer flow.
Please refer to Section:
Using the BeerTender
®
System to check that
you have properly set
up the BeerTender
®
.
No beer is being
dispensed.
The DraughtKeg
TM
is
empty.
Replace the
DraughtKeg
TM
with a
new one.
There is no
DraughtKeg
TM
inside
the BeerTender
®
appliance.
Install a DraughtKeg
TM
inside the BeerTender
®
appliance.
The BeerTender
®
appliance tap handle is
not correctly
installed/positioned.
Install/position the
tap cover correctly.
You cannot close the
lid.
The tap cover has
not been positioned
correctly.
Position the tap cover
correctly.
The DraughtKeg
TM
has not been correctly
installed.
Install the tap correctly.
Ensure the draught
tube has been installed
completely and is not
preventing the lid from
closing.
The BeerTender
®
appliance produces too
much foam when
dispensing beer.
The DraughtKeg
TM
has
not reached the right
dispensing
temperature.
Allow the DraughtKeg
TM
to cool to the right
temperature. You can
rely on the temperature
indicator on the
control panel of your
BeerTender
®
appliance.
The DraughtKeg
TM
has been shaken.
Wait 4 hours before
dispensing beer.
The tap handle is being
moved too slowly.
Firmly and quickly pull
the handle down and
forward as far as it
will go.
Beer flows out too
slowly.
The tap handle is not
open all the way.
Open the tap
completely.