Filter
Top Products
12
11. Drawing off hot water
If you do not change the settings using the Rotary Switch
(1), the water quantity last adjusted will be drawn off auto-
matically.
Install the hot water nozzle (see Fig. 5 ) to obtain perfect
water flow. Do not replace the replaceable hot water nozzle
(16) directly after drawing off water, because the nozzle is
hot after the draw-off operation.
At the start of the water draw-off operation there can be
splashing Avoid direct contact with the skin!
Ⅲ READY
Ⅲ Place a cup under the replaceable hot water nozzle (16).
Ⅲ Open the steam / hot water draw-off tap (14) (Fig. 13).
Ⅲ The illuminated ring (2) is active.
Ⅲ For example, 140 ML
Ⅲ WATER
Ⅲ Adjust the required water quantity by turning the Rotary Switch
(1).
Ⅲ For example, 200 ML
Ⅲ WATER
Ⅲ If the required water quantity is reached, the following message
is displayed:
Ⅲ CLOSE TAP
Ⅲ Close the steam / hot water draw-off tap (14).
Ⅲ READY
Before CLOSE TAP water may still escape the system.
12. Drawing off steam
To ensure perfect operation, clean the 2-stage frothing jet
(15) regularly. Screw the nozzle off as described in. Hold the
nozzle at the top and at the bottom end and screw it apart
(Fig. 17). Thoroughly rinse the 3 parts under running water.
Make sure the nozzle has engaged properly. If the nozzle is
clogged with dried milk or has not been attached properly, it
might suddenly come off during operation.
Install the replaceable 2-stage frothing jet (Fig. 6). This is
included in your Welcome Pack. Do not replace the re-
placeable steam/hot water nozzle (15) directly after drawing
off steam, because the nozzle is hot after the draw-off
operation.
Steam can be used for heating liquids and frothing milk for
cappuccino. Make sure that the replaceable 2-stage frothing
jet (15) is pushed upwards when liquids are heated. To froth
liquids, push the 2-stage frothing jet downwards, turning it
slightly.
During frothing some water will escape the system before
the actual frothing process. This does not affect the result,
e.g. when frothing milk.
At the start of the steam draw-off operation there can be
splashing The 2-stage frothing jet becomes hot. Avoid direct
contact with the skin!
Ⅲ READY
Ⅲ Place a cup under the 2-stage frothing jet (15) and immerse it in
the milk to be frothed or the liquid to be heated.
Ⅲ Press the steam pre-selection key (8).
Ⅲ HEATING