Filter
Top Products
Leveling and Door Alignment
Leveling
After
installing, plug
the
refrigerator's
power
cord
into
a 3-prong grounded
outlet
and push
the
refrigerator into
the
final position.
Your refrigerator has
two
front
leveling
legs-
one
on
the
right and one on the left.
Adjust
the
legs
to
alter
the
tilt
from
front-to-back
or
side-
to-side. If
your
refrigerator
seems
unsteady,
or
you
want
the doors
to
close more easily, adjust
the
refrigerator's
tilt
using
the
instructions
below:
Remove
the
base grille. Refer
to
the
Base
Grille Installation section.
2 Turn
the
leveling leg
to
the
left
to
raise
that side
of
the
refrigerator
or
to
the right
to
lower
it.
It
may
take several
turns
of
the leveling leg
to
adjust
the
tilt
of
the
refrigerator.
0 NOTE
--------
A flare
nut
wrench
works
best,
but
an
open-end wrench
will
suffice.
Do
not
over-tighten.
3 Open
both
doors again and check
to
make
sure
that
they
close easily.
If
the
doors do
not
close easily,
tilt
the
refrigerator slightly
more
to
the rear by turning both leveling
legs
to
the
left.
It
may
take several more
turns, and
you
should turn
both
leveling
legs
the
same mount.
4 Replace
the
base grille.
INSTALLATION
23
Door Alignment
The left refrigerator door has
an
adjustable nut,
located
on
the bottom hinge,
to
raise
and
lower
the door for proper alignment.
If
the space between your doors is uneven, follow
the instructions below
to
align the doors evenly:
Use
the wrench (included with the Use &
Care
Guide)
to
turn the
nut
in the door hinge
to
adjust
the height.
To
the right
to
raise or to the left to
lower the height.
The right refrigerator door does not have
an
adjustable nut.
If the space between your doors is uneven, follow
the instructions below
to
align the right door:
With one hand,
lift up both the inner
and
outer door sections
of
the right door to raise
them at the
middle hinge. (Opening the door
may make
lifting
it
easier)
2 With the other hand, use pliers
to
insert the
snap ring on the
middle hinge of the inner
door section
as
shown.
Do
not insert the ring
on
the hinge
of
the outer door section.
3 Insert additional
snap
rings until the right door
is
aligned. (Two
snap
rings are provided
with
the unit.)
I