Filter
Top Products
OPERATING INSTRUCTIONS
17
ENGLISH
USING THE CLOCK AND TIMER
HOW TO SET THE CLOCK
The clock should be set to the correct time of day for
the automatic oven timing functions to work properly.
The time of day cannot be changed during cooking or
self-clean mode.
ᕡ Press the “CLOCK” pad once to set.
ᕢ Press the number pads to enter the
time. Press the number pads the same
way you read them. For example, to set
12:12, press the number pads 1, 2, 1,
and 2 in that order.
If number pads are not pressed within
30 seconds after you press the
“CLOCK” pad, the display reverts to
the original setting. If this happens,
press the “CLOCK” pad and reenter
the time of day.
ᕣ Press the “START” pad.
To check the time of day when the display is showing
other information, simply press the “CLOCK” pad.
HOW TO CHANGE HOUR MODE ON CLOCK
(12HR OR 24HR)
Your control is set to use a 12-hour clock. If you
would prefer to have a 24-hour time clock, follow the
steps below.
ᕡ Press the “CLOCK” pad for 3 seconds.
ᕢ Press the number 1 pad once for 12hr
and twice for 24hr.
ᕣ Press the “START” pad to accept the
desired change.
HOW TO SET THE TIMER
The timer does not control oven operations. The
maximum setting on the timer is 11 hours and 59
minutes.
ᕡ Press the “TIMER ON/OFF” pad once
for minutes and seconds, press the pad
twice for hours and minutes.
ᕢ Press the number pad to select the
desired time. A maximum of 59 minutes
can be set using the minutes and
seconds function. To set times longer
than 59 minutes use the hours and
minute function (press the pad twice).
NOTE: If you make a mistake, press the
“TIMER ON/OFF” pad and begin again.
ᕣ Press the “TIMER ON/OFF” pad to start
the countdown.
NOTE: If “TIMER ON/OFF” is not pressed
the timer will return to the time of day.
ᕤ When the timer reaches :00, “End” will
show in the display. The clock will sound
with 3 beeps every 15 seconds until
“TIMER ON/OFF” pad is pressed.
NOTE: If the remaining time is not in the display, recall
the remaining time by pressing the “TIMER ON/OFF”.
HOW TO CANCEL THE TIMER
Press the “TIMER ON/OFF” pad.
POWER OUTAGE
If a flashing time is in the display, you have
experienced a power failure. You will need to reset
the clock time.
Press the “CLOCK” pad once to reset. Enter the
correct time of day by pressing the appropriate
number pads. Press the “START” pad.