Filter
Top Products
13
K/SK/es..0
GB
Operation and control elements
Setting the temperature
W Turn the temperature control 1 with a coin until the
desired temperature is indicated in the display. The slot
positions mean:
Setting 1 = highest temperature,
lowest cooling setting
Setting "max." = lowest temperature,
highest cooling setting
W Recommended temperature setting: 5°C.
Please note that the temperature inside your appliance will
depend on where you have put it, the temperature in the
room, how often you open the door, and what you put in it.
If necessary, re-adjust the temperature control.
Temperature setting display
- When the temperature display 3 is illuminated, this indi-
cates that the appliance is running.
- The five blocks in the display each relate to a different
temperature range. They indicate the refrigerator tem-
perature setting you have selected.
- Within the temperature / setting range, e.g. when the dis-
play reads 5 °C to 7 °C, or between two settings*, the tem-
perature can be set slightly colder. If required, slowly turn
the tempera-ture control 1 further - the light displaying
the temperature range, e.g. 5 °C, flashes for a short time.
This confirms the colder setting within the small tempera-
ture range.
SuperCooling*
The SuperCooling button 2 switches the appliance to
maximum cooling. This will enable you to achieve tempo-
rarily lower refrigerating temperatures.
It is recommended particularly if you wish to cool large
quantities of food, drinks, freshly baked cakes or meals
rapidly
W To switch on: Press the SuperCooling button 2 briefly
so that it lights up.
- The refrigerator temperature will drop to its lowest value.
W To switch off: Press the SuperCooling button again so
that it goes dark.
NB:
- The SuperCooling function uses slightly more energy.
After approx. 6 hours, however, the appliance switches
back automatically to normal energy-saving operation.
Fan switch*
for re-circulated air cooling 4:
You can use the fan switch as required to:
- chill large quantities of fresh food fast;
- keep the temperature evenly distributed throughout the
entire refrigerator compartment. The air will circulate
more intensively, thus keeping all the different areas in the
appliance at the same temperature and ensuring that all
the food inside is chilled at the same temperature.
W You are recommended to always use the fan switch:
- in high room temperatures (approx. 30°C or higher) or
- if the air humidity is high, e.g. during the summer.
W To switch on: Press the fan button 4 briefly so that it
lights up.
W To switch off: Press the fan button again so that it goes dark.
NB:
- To save energy, the fan will switch off automatically when
the door is open.
You are advised to clean the appliance before switching it
on for the first time (see "Cleaning").
Connecting to the mains
Power supply (AC) and voltage
at the operating point must comply with the details on
the type plate, which is located inside the appliance on the
left, fig. A.
W Connect the appliance with a properly earthed fused
plug and socket only.
W The socket must be fused with a 10 A fuse or higher, it
must be away from the rear of the appliance and must be
easily accessible.
W Do not
- connect to stand-alone inverters,
- operate with so-called energy-saving plugs - this can
damage the electronic system,
- connect to the supply with other equipment using an
extension cable - risk of overheating.
W When removing the mains cable from the back of the ap-
pliance, remove the cable holder as well so as to avoid
vibration noise.
The wires in the mains lead are coloured in accordance with
the following code: green/yellow = earth, blue = neutral,
brown = live.
Warning! This appliance must be earthed.
Non-rewireable plugs BS 1363
If this machine or appliance is fitted with a non-rewireable
plug, the following information applies: If the socket outlets
are not suitable for the plug supplied with this product, it
must be cut off and an appropriate plug fitted. The plug cut
from the flexible cord should be disposed of and on no ac-
count be inserted into a 13 A socket elsewhere in the house
(electric shock hazard).
The fuse cover must be re-fitted when changing the fuse,
and if the fuse cover is lost the plug must not be used until
a suitable replacement is obtained. The colour of the cor-
rect replacement cover is that of the coloured insert in the
base of the plug, or the colour that is embossed in words on
the base of the plug (as applicable to the design
of the plug
fitted). The correct rating of the replace
ment fuses that are
ASTA approved to BS 1362 should be fitted. Replacement
fuse covers may be purchased from your local electrical
suppliers, electricity showroom or approved service agent.
Switching the appliance on and off
fig. A1
W To switch on: Turn the temperature control 1 with a coin
so that the slot is pointing to setting 2.
- A green light on the temperature display will light up and
indicate that the appliance is in normal mode.
- The interior light will switch on.
W To switch off: Set the temperature control to "0".
- The temperature display and all buttons will go out.
- The interior light will go out.
* Depending on model and options
max.
0
2
3
4
A1
Ventilator
SuperCool
1
°C
9
7
5
3
1