Filter
Top Products
21
WTE...6
GB
Your appliance is constructed and manufactured to give func-
tional safety and a long life.
Should however a fault occur during operation, then please
check whether the fault can possibly be due to an operator’s er-
ror, because in this case you must pay for the costs arising, even
during the warranty period.
You can remedy the following faults yourself by checking the pos-
sible causes:
Fault possible cause and remedy
Appliance is not working, display is dark
- Is the appliance switched on properly?
- Is the mains plug in the power point properly?
- Is the fuse in the plug OK?
Noises are too loud
- Is the appliance standing firmly on the floor, are units or ob-
jects standing next to it made to vibrate by the running of the
refrigerating unit? Perhaps move the appliance away a little,
even up using the adjustable feet, move bottles and contain-
ers away from one another.
- The following are normal: flowing sounds, a bubbling or
splashing, these come from the refrigerant that flows in the
refrigerant circuit.
A slight clicking sound, this always happens when the refriger-
ating unit (the motor) automatically switches on or off.
A humming motor. It is a little louder briefly, when the unit
switches itself on. After the door has been open a long time,
the refrigerating capacity automatically increases.
Alarm sounds, temperature is not cold enough
- Is the appliance door closed properly?
- Is the ventilation sufficient?
Perhaps free up the ventilation grilles.
- Is the ambient temperature too warm?
(see section “Definitions”)
- Has the appliance been open too often or for too long?
- Perhaps wait and see if the required temperature is re-set by
itself.
- Please be aware that, as with other forms of storage, depend-
ing on the type of label adhesive, a slight mould can form. The
remedy in this case is to carefully clean adhesive residues
from the bottles.
Appliance sometimes feels warm on the outside surfaces
- This is completely normal. The heat of the refrigerant circuit is
used to prevent condensation.
Faults - Problems?
Your old appliance: This contains some reusable
materials and should be disposed of properly - not
simply with unsorted household refuse.
•
Discarded appliances should be disabled: Remove
the plug, cut through the connection cable and
render the catch unusable so that children cannot
become trapped inside.
•
Ensure that the refrigerant circuit is not damaged when the
appliance that is no longer needed is taken away for disposal.
•
Details of the refrigerant can be found on the type plate.
•
Appliances which are no longer needed must be disposed of
in a professional and appropriate way, in accordance with the
current local regulations and laws.
When there are none of the above causes and you have
not been able to remedy the problem yourself or when
a “F 0” to “ F 5” appears in the temperature display, this
means: there is a fault. In this case, contact your nearest
Customer Service Centre (directory enclosed). Inform them of
this message, also the
name of the appliance 1,
service number2,
appliance number 3
from the rating plate. This facilitates fast,
targeted service. The rating plate is located
on the left-hand side inside the appliance.
Leave the appliance closed until the Cus-
tomer Care Department engineer arrives, to prevent a further loss
of cold.
Disposal
Customer Care Department and rating plate