Filter
Top Products
18
WTE...6
Operating elements and controls
Wine storage
23 Bordeaux bottles can be stored in the upper compartment and
in the lower compartment up to 41 Bordeaux bottles .
Switching on and off
W To switch on: Press On/Off , so that the temperature displays
light up/flash.
W To switch off: Press On/Off for about a second, so that
the temperature displays go out.
Setting the temperature
The wine cooler zone can be set between 5 and 18 °C .
W The wine cooler zone is divided into two areas, which can be
set to different temperatures, if required.
The “Up” and “Down” buttons on the left of the
display control the upper compartment .
The “Up” und “Down” buttons on the right of the
display control the lower compartment.
W To lower the temperature/colder: Press the Down button.
W To raise the temperature/warmer: Press the Upbutton.
- During setting, the setting value set flashes in the display.
- When the temperature setting buttons are pressed for the first
time, the last value set appears in the display(= desired value).
- Repeated short presses on the buttons changes the value set
in 1 °C steps. longer presses change the value continuously.
- About 5 seconds after the last press of the buttons, the elec-
tronics automatically change over and the actual fridge tem-
perature (= actual value) is displayed.
- The altered temperature gradually adjusts itself slowly to the
new value.
Temperature display
In normal operation:
- the average wine cooler temperature is displayed
The display flashes, when
- you alter the temperature setting,
- the wine cooler temperature is too cold or
- the temperature has risen by several degress, as an indication
of a loss of cold, e.g. when re-arranging the bottles. After you
have finished storing or re-arranging bottles, the electronics
automatically adjust the temperature to the last setting.
W If a “F 0” to “F 5” should appear in the display, there is a fault
with the appliance. Then please contact your Customer Care
Service and inform them of this message. This facilitates fast,
targeted service.
Alarm - Acoustic warning
The acoustic warning helps you to protect your stored wine and
to save energy.
W The acoustic tone stops when the Alarm Off button is
pressed
- automatically, when a cold enough storage temperature
is reached again or
- the door is closed.
Door alarm
- It always sounds, when the door is open for longer than about 60
seconds.
The tone remains switched off until the door is opened. When
the door is closed, the alarm function is automatically readied
again.
Temperature alarm
It always sounds, when the wine storage temperature is too warm
or too cold
The temperature display continues to flash until the alarm condi-
tion has ended. Then it switches from flashing to being perma-
nently lit. At the same time the acoustic warning is again auto-
matically readied for operation.
Ventilator switch
The ventilator switch increases the relative air humidity in the
wine cooler zone. This achieves an environment in the interior
which corresponds to that of a wine cellar. The increased air
humidity prevents the corks drying out.
W To switch on:
- Briefly press “Ventilation” button so that it lights up.
W To switch off: briefly press again, so that the ventilator sym-
bol in the display goes out.
The ventilator then runs only in parallel with the compressor =
lower air humidity.
Note:
- When the ventilator is switched on, energy consumption is
increased.
- To save energy, the ventilator switches off automatically when
the door is open.
1 Temperature display and settings display
2 Setting buttons for temperature, lower wine cooler zone
3 Alarm button
4 Setting buttons for temperature, upper wine cooler zone
5 On/Off button
6 Ventilator button
7Light setting
Ventilation
Light
6
5
4 1 2
3 7