Filter
Top Products
14
WTE...6
Installation instructions
W When installing/building in, make sure that the pipes of the
refrigerant circuit are not damaged.
W The installation space for your appliance must have a volume
of 1 m
3
per 8 g of refrigerant R 600a in accordance with the
standard EN 378, so that in the event of a leak in the refrig-
erant circuit no flammable gas-air mixture can occur in the
appliance’s installation space. The details of the amount of
refrigerant contained is to be found on the rating plate inside
the appliance.
W Avoid sites in the area of direct sunlight, near cookers, heat-
ers and the like, and in damp areas or where water can be
splashed.
W The ventilation grilles must not be blocked. Always en-
sure good ventilation! For more information on this subject,
please see the installation and conversion instructions.
W Do not place any appliances that give off heat, e.g. micro-
wave, toaster, etc. on the appliance.
W Remove all transport safety devices,
- remove sticky tape or spacers from the shelves.
- Remove all protective films: on the front and side walls*.
Connecting to the electrical supply
Type of current (alternating current) and voltage
at the installation site must match the details on the rating
plate. This is located on the left-hand side inside the appli-
ance,
W Only connect the appliance via a correctly installed
shockproof socket.
W The power point must be protected with a fuse of 10 A or
higher, be outside the area of the back of the appliance and
be easily accessible.
W Do not
- connect the appliance to island power inverters (e.g. battery),
- operate the appliance in combination with so-called energy-
saving plugs - the electronics can be damaged,
- connect the appliance with other appliances via an extension
cable - danger of overheating.
W When taking the mains cable from the back of the appliance
remove the cable holder - otherwise vibration noises!
Disposal notes
The packaging is made of recyclable materials.
- Corrugated board/board
- EPS moulded parts
- Polythene sheets
- Polypropylene straps
•
Keep packaging materials away from children - poly-
thene sheets and bags can cause suffocation!
•
Please return the packaging to an official collection
point.
Technical safety
W To avoid personal injury and material damage, only transport
the appliance when packed in the packaging materials and
install with two people present.
W The refrigerant contained within the appliance, R 600a, is
environmentally friendly, but flammable.
W Do not damage the pipes of the refrigerant circuit. Spurting
refrigerant may lead to eye injuries or may ignite.
W If refrigerant escapes, remove naked flames or sources of igni-
tion from near where it is escaping, pull out the mains plug and
ventilate the room well.
W In the event of damage to the appliance, check with the sup-
plier immediately - before connecting to the mains supply.
W To ensure safe operation of the appliance, only install and
connect the appliance in accordance with the operating in-
structions.
W In the event of fault, disconnect the appliance from the mains
supply: remove the mains plug (do not pull on the mains cable
to do this) or remove or turn off the fuse.
W Only have repairs and interventions on the appliance
carried out by the Customer Care Service, other-
wise serious risks to the user may arise. The same
applies to changing the mains cable.
Safety when using
W Do not store any explosive materials or aerosols with flam-
mable propellants, such as butane, propane, pentane, etc. in
the appliance. Any leaking gases could be ignited by electrical
components. You can recognise such aerosols by the printed
contents or by a flame symbol.
W High-proof alcohol should only be stored tightly sealed and
upright.
W Do not handle naked flames or ignition sources inside the ap-
pliance.
W Do not use any electrical devices inside the appliance (e.g.,
steam cleaners, heaters, etc.)
W Plinth, drawers, doors, etc. are not intended to be stood on, so
do not mistreat them in this way.
W This appliance is not designed for use by persons (or children)
with physical, sensory or mental impairment or persons, who
do not have sufficient experience and knowledge, unless they
have been instructed or initially supervised by a person, who
is responsible for their safety, in the use of the appliance. Chil-
dren should not be left unsupervised to make sure that they do
not play with the appliance.
W Avoid long skin contact with cold surfaces or cooled products.
This can lead to pain, feelings of numbness and frostbite. In
the event of skin contact lasting a while, take protective steps,
e.g. use gloves.
W Do not consume food that has been stored for too long, it can
cause food poisoning.
Safety and warning information
The wires in the mains lead are coloured in accordance with the
following code: green/yellow = earth, blue = neutral, brown = live.
Warning! This appliance must be earthed.
Non-rewireable plugs BS 1363
If this machine or appliance is fitted with a non-rewireable plug,
the following information applies: If the socket outlets are not
suitable for the plug supplied with this product, it must be cut off
and an appropriate plug fitted. The plug cut from the flexible cord
should be disposed of and on no account be inserted into a 13 A
socket elsewhere in the house (electric shock hazard).
The fuse cover must be re-fitted when changing the fuse, and if
the fuse cover is lost the plug must not be used until a suitable
replacement is obtained. The colour of the correct replacement
cover is that of the coloured insert in the base of the plug, or the
colour that is embossed in words on the base of the plug (as ap-
plicable to the design of the plug fitted). The correct rating of the
replacement fuses that are ASTA approved to BS 1362 should be
fitted. Replacement fuse covers may be purchased from your lo-
cal electrical suppliers, electricity showroom or approved service
agent.