19
WTE...6
GB
Operating elements and controls
Additional functions
Via the setting mode you can use the child safety device and
change the brightness of the display. With the child safety device
you can protect the appliance against being switched off uninten-
tionally.
To activate setting mode:
• Press ventilator button for about 5 seconds - the ventila-
tor button flashes - the display shows c for child safety
device.
Note: The respective value to be changed flashes.
• By pressing the Up/Down button, select the desired function:
c = child safety device, h = brightness
• Now by pressing the ventilator button briefly, select/confirm
the function:
When c = child safety device
by pressing the Up/Down button, select
c1 = child safety device on or
c0 = child safety device off and confirm with the
ventilator button. When the symbol is lit, the child safety device
is active.
When h = brightness
by pressing the Up/Down button, select
h1= minimum to
h5 = maximum brightness and confirm with the venti-
lator button.
To leave setting mode:
• Press the On/Off button to end setting mode; after 2
mins. the electronics automatically switch over. Normal
operation is active again.
Equipment
Light setting dim mode
You have the option of setting the dim mode using the “Light” but-
ton. You can select the intensity with which the light shines after
the door is closed.
W If the button is not lit, after the door is closed, the light dims
slowly and then goes out completely.
W To activate the dim mode, briefly press the “Light” button,
until it lights up.
By additionally pressing the lower “Up” or “Down”
buttons,you can set the brightness.
With “Light” and “Up” the light is set more brightly,
with “Light” and “Down” the light is set more dimly.
Both wine cooler zones are controlled at the same time.
Interior light
An LED light is integrated in the upper and lower compartment.
The interior light can be switched on and off with the “Light” but-
ton.
The light may only be changed by the Customer
Care Department or by technicians trained to do so.
CAUTION
Laser radiation class 1M.
When cover is open, do not look at directly with
optical instruments.
Labels
The appliance is fittedwith one la-
bel holder per wooden shelf. Use
these labels to identify the wine
type stored on the wooden shelf.
Use a soft pencil to write on the
labels. The writing can then be
easily corrected or erased,if nec-
essary.
Additional labels can be bought from your dealer .
Fastening: Clip the label holder on the wooden shelf at the
desired place. The label is then pushed in under the label holder
from the side.
Folding down the wooden shelf
In each wine cooler compartment
your appliance has a wooden
shelf that can be folded down. Use
this option to safely store bottles
of wine that have already been
opened.
To fold down the wooden shelf,
press the catch that is located
under the panel to the side. The
wooden shelf folds down.
Taking out the wooden shelves
The fold-down wooden shelf runs
on pull-out rails. To take out the
wooden shelf, lift the shelf upwards
off the pull-out rail and then pull it
out forwards. Make sure that the
wooden shelf does not remain
caught on the hook at the back. To
put back, push the shelf under the
hook at the back and then press
the wooden shelf onto the rails, so that they audibly engage.
All other wooden shelves are only
set on the rails and do not have to
be hooked on.
Light
Ventilation