Filter
Top Products
17
WTE...6
GB
Fastening in the kitchen cupboard
W All fasteners are supplied with the applaince.
W Attach aligning panel 1with
screws 2into the pre-bored holes
in the top of the appliance
W Stick cover strip 3 onto the side wall of the
appliance on the handle side and flush with the
front. Remove protective film and stick the strip
on. If necessary, shorten the strip to the
height of the recess.
W With 16 mm thick cupboard walls =
568 mm wide recess: Clip spacer 4
onto the bearing bracket 5in the slot
area .
- With 19 mm thick cupboard walls =
562 mm wide recess. The spacer is not
required.
W Position the mains cable using a
piece of string so that the appli-
ance can easily be connected to
the electricity supply after it has
been built-in.
- Push the appliance 3/4 of the way
into the recess.
W Push appliance into the recess until the
lower bearing bracket 6 touches the front
of the cupboard wall. The bearing bracket
must be on the floor of the recess.
W Check the fit of the appliance and the door. If necessary, make
level:
- The appliance must lie tightly against the top of the side wall
on the hinge side.
- Align the door 6 flush to the surrounding cupboard doors us-
ing the slots in the bearing bracket.
W Screw plastic angle 7 with M5 screws
8 at the bottom of the appliance, and
align flush with the front edge of the
floor of the cupboard .
W Fasten/fix appliance in the recess with
fixing plate screws .
Through the upper bearing bracket
5screw in screw bl , pressing the
appliance firmly against the cupboard
wall.
Screw on the lower bearing
bracket 6 with screw 9 .
Screw on plastic angle
7with screw 9. Fold down
the flap of the angle.
- Attach the aligning panel 1 from below with
two screws bm
- Make sure that all screws are tightly fastened.
The manufacturer is constantly working on the development of
all models. Please understand therefore that we must reserve the
right to make changes to form, equipment and technology.
Fastening and mounting
9
10
7
4
11
8
1
2
3
1
x
1
x
2
2
x
x
1
x
4
1
4 x 29
M 5 x 15
x
x
1
x
1
x
4x19
4x14
3,5x9,5
SW 5
19 mm
3
x
➀
➁
➃
➄
➅
➆
➇
➄
➉
➈
➅
➆
➈
➀
11
➂