Filter
Top Products
Impinger II – Digital Advantage Ops Manual –Dom & Int’l
15
CONVEYOR REMOVAL
1. Remove crumb trays on both ends of the conveyor. 2. Remove drive sprocket shield.
3. Grasp rubber coupling firmly and pull toward
conveyor.
4. Coupling will snap back allowing removal of
conveyor. (Set screw on conveyor side is a spring
loaded ball detent and is NOT to be tightened firmly.
5. Proceed to opposite end of conveyor and lift up and
push forward.
6. Then return to control end of the conveyor and
remove conveyor from oven cavity. Reassemble in
reverse order.