Filter
Top Products
Ice Machine Operation Section 3
3-10
Part Number 80-1214-3
PROCEDURE TO CLEAN HEAVILY SCALED FLAKE/CHIPLET ICE MACHINES QF400/QC700/QF800/QF2300
Step 1 Remove front and top covers, set the toggle
switch to the OFF position.Remove all ice from the bin.
Step 2 Remove front and top covers and set the toggle
switch to the OFF position.
Step 3 Disconnect water supply line at float valve quick
disconnect by depressing stainless steel lever.
Step 4 Refer to chart below:
Premix cleaner with lukewarm water in a non-
metallic container.
Step 5 Remove all water from the evaporator and water
reservoir. Start an ice making cycle by moving the toggle
switch to the ICE position. Water will flow through the
water dump valve and down the drain for 45 seconds.
After 45 seconds move the toggle switch to the OFF
position. Remove the plug from the top cover of the
water reservoir. Add the entire cleaner/water solution
and re-install the plug.
Leave the cleaner/water solution in the evaporator
for a minimum of 4 hours.
Step 6 Move the toggle switch from OFF to ICE. The
cleaner/water solution will flow through the water dump
valve and down the drain for 45 seconds.
Step 7 Move the toggle switch to the OFF position,
then follow the standard cleaning and sanitizing
procedures for the model ice machine you are cleaning.
Model
Water
Reservoir
Capacity
Mix Cleaner and Water
Use Ice machine cleaner
part number 000000084
only
Cleaner Water
QF400 48 oz (1.4 L) 32 oz (0.94 L) 16 oz (0.5 L)
QF800/
QC700
48 oz (1.4 L) 32 oz (0.94 L) 16 oz (0.5 L)
QF2300 72 oz (2.1 L) 48 oz (1.4 L) 24 oz (0.7 L)