Filter
Top Products
MULTI-CYCLE TIMER ADJUSTMENT - OPTION
Determine the cycle time of your machine. This can be found in the CHARTS section of
this manual under TIMER SETTINGS. Next multiply the cycle time by the number of
cycles the machine should run and subtract one fourth of the cycle time. This is the
cumulative number of seconds for which to set the switches.
EXAMPLE: Cycle time of machine ........................... = 28 sec
Desired number of cycles ...................... = 3
Total seconds for 3 cycles (28 X 3) ........ = 84 sec
One fourth of cycle time (28/4) ...............= 7 sec
Number of seconds to set timer (84 - 7) = 77 sec
2 MAINTENANCE
PROCEDURES 2-5
Remove access covers from compactor.
Remove hoses (4, for 88SC & 250SC, 100SC & 250VL).
Remove cylinder pins.
Remove cylinders (2, for 88SC & 250SC, 1, for 100SC & 250VL).
To install the cylinders, reverse the above steps.
1.
2.
3.
4.
5.
CYLINDER REMOVAL INSTRUCTIONS
RAM STOP FORWARD - OPTION
To convert the RJ-88SC, RJ-100SC, RJ-250SC, and RJ-250VL to Ram Stop Forward,
move the purple solenoid wire from terminal # 8 to terminal # 10. Reset timers by the
settings shown in the TIMER SETTINGS section under CHARTS in this manual.
Change the “START-FORWARD” key lock push button legend to “START-REVERSE”.
Change the “REVERSE” button legend to “FORWARD”.
WARRANTY AND SERVICE ON MOTORS
If the compactor motor fails under warranty, have it checked by a qualified electrician or
service person. If there is no problem with fuses or wiring, the motor should be taken to
the nearest authorized motor warranty shop. If you do not have a list of qualified shops,
contact Marathon Equipment Co. The motor warranty shop will be able to inspect the
motor and determine if it is factory defective. If the motor failed due to defects in materi-
al or workmanship, the warranty shop will repair or replace the motor at the manufactur-
ers expense. If motor failure was not due to defective material or workmanship, it will be
repaired only if customer agrees to pay for expenses. Marathon Equipment Co. will not
absorb cost for pickup and delivery to service centers. Removal and reinstallation are
covered in the standard warranty policy.