Filter
Top Products
4 HAULER INFORMATION
HAULER INSTRUCTIONS - HYDRAULIC TAILGATE OPERATION
(FOR OPTIONAL HT UNITS) 4-3
06-0105
WHEN LIFTED
DANGER
STAND CLEAR OF
TAILGATE
CAUTION
STAND CLEAR OF TAILGATE WHEN LIFTED.
TRUCK MUST BE ON FIRM, LEVEL SURFACE BEFORE LIFTING TAILGATE.
FRONT AND REAR HOLD DOWNS MUST BE ENGAGED.
TILT HOIST BEFORE LIFTING TAILGATE.
*
*
*
*
CONTAINER/COMPACTOR
LATCH
TRUCK HOIST
TRUCK HOIST
TAILGATE
CONTENTS
1.
2.
ATTACH HYDRAULIC
CONNECTION.
DISENGAGE LATCH.
(EACH SIDE)
3.
4.
5.
RAISE HOIST.
LIFT TAILGATE.
EMPTY CONTENTS.
6.
7.
8.
9.
10.
11.
CLEAN SEAL AS DESCRIBED IN THE “HAULER INSTRUCTIONS - GENERAL” IN THIS SECTION
OF THE MANUAL. NOTE WARNINGS.
LOWER TAILGATE AS LOW AS POSSIBLE.
LOWER HOIST.
LOWER TAILGATE COMPLETELY.
ENGAGE AND TIGHTEN LATCHES.
REMOVE HYDRAULIC CONNECTION.
The truck hoist must have a hydraulic selector valve with 1500 psi, min. to operate the
hydraulic tailgate. The hydraulic tailgate is supplied with one 1/2” NPTF male quick dis-
connect mounted on the drivers side of the unit. A 1/2” female quick disconnect is sup-
plied for use on the truck hoist valve plumbing.