Filter
Top Products
1 OPERATION
OPERATING INSTRUCTIONS FOR RJ-88SC, RJ-100SC, & RJ-250SC
1-5
First, place the material to be discarded into the
compactor.
Note: If you are loading the compactor through a door or
gate, close it before starting the compactor. Refer to
“Optional Loading Configurations” in the Decal Placement
section to determine how your compactor is set up.
Insert the key into the key switch. Turn it clockwise and depress for 1 to
2 seconds and release. The unit will make one complete cycle, then
stop.
Repeat, if necessary, after the compactor has stopped.
When you have finished using the compactor, remove the key from the
key switch.
IN CASE OF EMERGENCY:
Push the large red button to STOP
MANUAL OVERRIDE INSTRUCTIONS (RAM STOP REAR ONLY - 88SC,
100SC, & 250SC)
If the ram is stopped in any position:
- To move the ram forward, turn the key switch clockwise and depress.
- To move the ram rearward, hold the reverse button down, turn and
depress the key switch, release the key switch, then release the
reverse button.
While the ram is moving:
- To reverse the ram while it is moving forward, press the reverse button.
- To cause the ram to move forward while it is moving rearward, depress
the key switch.
NOTE: Refer to Optional Controls for Manual Override on Ram Stop Forward Machines.
1.
2.
3.
4.