Filter
Top Products
1 OPERATION
OPERATING INSTRUCTIONS FOR RJ-250VL 1-6
First, place the material to be discarded into the
compactor.
Note: If you are loading the compactor through a door or
gate, close it before starting the compactor. Refer to
“Optional Loading Configurations” in the Decal Placement
section to determine how your compactor is set up.
Insert the key into the key switch. Turn it clockwise and release. The unit
will make one complete cycle, then stop.
Repeat, if necessary, after the compactor has stopped.
When you have finished using the compactor, remove the key from the
key switch.
IN CASE OF EMERGENCY:
Push the large red button to STOP
MANUAL OVERRIDE INSTRUCTIONS (RAM STOP REAR ONLY - RJ-250VL)
If the ram is stopped in any position:
- To move the ram forward, turn the key switch clockwise and release.
- To move the ram rearward, hold the reverse button down, turn and
release the key switch, then release the reverse button.
While the ram is moving:
- To reverse the ram while it is moving forward, press the reverse but-
ton.
- To cause the ram to move forward while it is moving rearward, turn
and release the key switch.
NOTE: Refer to Optional Controls for Manual Override on Ram Stop Forward Machines.
1.
2.
3.
4.