Marvel Group 6GARMP Refrigerator User Manual


  Open as PDF
of 40
 
TROUBLESHOOTING YOUR BEVERAGE AND WINE REFRIGERATOR
Problem Possible Cause Remedy
Unit not cold enough
Adjust temperatures (See “Set Tempera-
tures” on page 6)
• Control set too warm
• Content temperature not stabilized.
• Excessive usage or prolonged door
openings.
• Airow to front grille blocked.
• Door gasket not sealing properly.
• Adjust temperature colder. Allow 24
hours for temperature to stabilize.
• Allow temperature to stabilize for at
least 24 hours.
• Airow must not be obstructed to
front grille. See “clearances” on
page 4.
• Check door alignment and/or replace
door gasket.
Unit too cold
Adjust temperatures (See “Set Tempera-
tures” on page 6)
• Control set too cold
• Door gasket not sealing properly.
• Adjust temperature warmer. (See
page 6, “set temperature”). Allow 24
hours for temperature to stabilize.
• Check door alignment and/or replace
door gasket.
No interior light. • Failed light bulb • Replace light bulb, see page 14.
Light will not go out when door is closed • Door not acvang light switch.
• Display light is turned on.
• Unit not level, level unit, (See page 4,
“leveling legs”)
• Verify the door is aligned properly,
refer to page 9 for instrucons.
• Turn o display light, shut door.
Noise or Vibraon • Unit not level • Level unit, see “Leveling Legs” on
page 4.
Unit will not run. • Unit turned o
• Power cord not plugged in.
• No power at outlet.
• Turn unit on. See “Starng your re-
frigerator” on page 6.
• Plug in power cord.
• Check house circuit.
Before you call for service
If the unit appears to be malfunconing, read through this
manual rst. If the problem persists, check the troubleshoong
guide below. Locate the problem in the guide and refer to the
cause and its remedy before calling for service. The problem may
be something very simple that can be solved without a service
call. However, it may be required to contact your dealer or a
qualied service technician.
Electrocuon Hazard - Never aempt to repair or perform
maintenance on the unit unl the main electrical power has
been disconnected. Turning the units control “o” does not
remove electrical power from the units wiring.
15
 previous next