Filter
Top Products
16
Fresh Food Features
Shelves
To avoid personal injury or property damage,
observe the following:
• Never attempt to adjust a shelf that is loaded with
food.
• Confirm shelf is secure
before placing items on
shelf.
• Handle tempered glass shelves carefully. Shelves
may break suddenly if nicked, scratched, or
exposed to sudden temperature change.
CAUTION
Spill-Catcher
T
M
Glass Shelves
Your refrigerator has Spill-Catcher
T
M
glass shelves. The
shelves have a spill retainer edge which allows for
easier clean up and some are equipped with a slide
out feature. To slide out, grasp the front of the shelf
and pull forward. Push in the shelf to return to the
original position.
To Remove a Shelf:
• Slightly tilt up the front and lift up
the rear of the shelf
, then pull the
shelf straight out.
To Lock the Shelf Into Another
Position:
• Tilt up the front edge of the shelf.
•
Insert the hook into the desired frame openings and
let the shelf settle into place.
• Be sure the shelf is securely locked at the rear.
Latches
Slide Out
EasyGlide ShelfEasyGlide Shelf
TM
(style may vary)
Elevator™ Shelf (select models)
T
he Elevator™ Shelf is equipped with a spill-ret
aining
edge and the EasyGlide™ slide-out feature. It can be
adjusted up or down without unloading.
To Slide Out EasyGlide™ Shelf:
• Grasp the front of the shelf and pull forward.
• Push the shelf in to return to original position.
To Adjust the Elevator™ Shelf:
• Pull out the knob on the crank handle.
• Rotate the crank
clockwise to raise the shelf, and
counterclockwise to lower the height of the shelf.
To Remove Elevator™ Shelf:
• Completely unload the shelf and pull the shelf
forward.
• Pull until the shelf stops.
• Slightly tilt up the front and pull the shelf straight
out. Continue pulling forward until the shelf is clear
of the frame.
To Replace Elevator™ Shelf:
• Align the shelf to the frame and push it all the way
back.
In ordinary use, the Elevator™ Shelf frame assembly
does
NOT require removal. Though unlikely, and not
recommended, the correct removal procedure is as
follows:
To Remove Frame Assembly:
• Unload the shelf completely.
• Slide the shelf forward about 2” and manually move
the two rear latches toward the shelf center.
• While supporting the entire shelf and frame from
underneath, lift slightly and rotate the assembly
approximately 30° to allow the rear mechanism to
clear the vertical rear side rails.
• The entire assembly can then be moved forward and
clear of the refrigerator compartment.
To Reinstall F
rame Assembly:
• Reverse the removal procedure. Be sure the shelf is
in a level position. W
hen the sliding shelf is pushed
to the rear, it will reposition the rear latches to their
correct operating position.