Maytag MFI2266AEW Refrigerator User Manual


 
Refrigerator is
leaking water
W
ater flow is
slower than normal
Ice storage bin
will not close
Water filter
indicator light is r
ed
Ice forms in inlet
tube to ice maker
29
Troubleshooting
Ice and Water
PROBLEM
POSSIBLE CAUSES
Plastic tubing was used to complete
water connection.
Improper water valve was installed.
Water pressure is low.
Improper water valve was installed.
Copper tubing has kinks.
Water filter is clogged or needs to be
changed.
Ice cube blockage
Water filter needs to be replaced.
Filter indicator sensor needs to be
re
set.
Water pressure is too low
Saddle valve not open completely.
Freezer temperature is too high.
The manufacturer recommends using copper tubing
f
or installation. Plastic is less durable and can cause
leakage.
The manufacturer is not responsible for
property damage due to improper installation
or water connection.
Check water connection procedure (see page 9).
Self-piercing and
3
1
6
saddle valves cause low water
pressure and may clog the line over time.
The
manufacturer is not responsible for property
damage due to improper installation or water
connection.
Water pressure must be between 35 to 100 pounds
per square inch to function properly. A minimum
pressure of 35 pounds per square inch is
recommended for refrigerators with water filters.
Check water connection procedure in your
Installation Instructions. Self-piercing and
3
16
saddle valves cause low water pressure and may
clog the line over time.
The manufacturer is not
responsible for property damage due to
improper installation or water connection.
Open water valve completely and check for leaks.
Turn off water supply and remove kinks. If kinks
cannot be removed, replace tubing.
Change water filter (see page 14).
Remove spilled ice cube(s)
before replacing ice
storage bin.
If filter is not available, replace with bypass filter.
See Water Filter, page 14.
See
Filter Status Indicator Light, page 10.
Water pressure must be between 35 to 100 pounds
per square inch to function properly. A minimum
pressure of 35 pounds per square inch is
recommended for refrigerators with water filters.
Open s
addle valve completely
.
See Temperature Controls, pages 10 and 11. Freezer
temperature should be between 0
°
to 2
° F (-18° to
-17° C) to produce ice.
WHAT TO DO