Filter
Top Products
5
Installation
To avoid electrical shock which can cause
severe personal injury or death, observe the
following:
• Disconnect power to refrigerator before removing
doors or drawer. Connect refrigerator door wire
harness and power
only after replacing doors or
drawer.
WARNING
To avoid damage to walls and flooring, protect vinyl
or other flooring with cardboard, rugs or other
protective material. Monitor water connection for 24
hours. Correct leaks if necessary.
CAUTION
Door and Drawer Removal
Some installations require door/drawer removal to
transport the refrigerator to its final location.
1. Unplug power cord from power source.
2. Remove toe grille (see page 4).
3. Remove top hinge cover
from right side refrigerator
door by removing Phillips
screw. Retain screw and
cover for later use.
4. Unscrew
5
⁄16” hex head
screws from top hinge to
remove hinge and retain
all screws for later use.
Note: For refrigerators in operation, shut off water
before disconnecting water line from the door.
6. Remove top hinge cover
from left side refrigerator
door by removing Phillips
screw. Retain screw and
cover for later use.
7. Disconnect wire harness
on top left side of
refrigerator door top
hinge. Release connector
by pressing junction
point with a flat blade
screwdriver or fingernail.
8. Disconnect waterline.
Hold “t
abbed” section of
waterline while rotating
the black locking collar
clockwise and slide back.
9.
Unscrew
5
⁄16” hex head
screws from top hinge to
remove hinge; ret
ain for
later use.
10. Lift left side refrigerator
door, along with top hinge,
from center hinge pin.
11. Remove Phillips screws to
remove right and left hinges;
r
et
ain all screws for later
use.
12. Remove both stabilizing
brackets with
3
⁄8” hex
head driver; r
et
ain
screws for later use.
Tabs
Connector
5
. Lift right side
refrigerator door from
center hinge pin.
Remove door closure
from center hinge pin
on the right side and
retain for later use.
Right
s
ide
door
closure