Filter
Top Products
28 16023415 ©2004 Maytag Services
Disassembly Procedures
To avoid risk of electrical shock, personal injury, or death:
disconnect electrical and gas supply before servicing.
WARNING!
Oven Door Hinge
NOTE: Removal of range from installation position is
required.
1. Disconnect power before servicing.
2. Remove oven door, see "Oven Door(s)-Door Removal"
procedure.
3. Remove maintop, see "Maintop Removal" procedure.
(Perform steps 1 – 6.)
4. Remove appropriate side panel (left or right), see
"Side Panel" procedure.
5. Remove screws securing hinge to front frame flange.
6. Complete hinge assembly may be removed.
7. Reverse procedure to reassemble.
NOTE: The door hinges are colored coded for ease of
installation. The upper spring hook is gold and
the lower spring hook is white.
Regulator
NOTE: Removal of range from installation position is
required.
1. Disconnect power before servicing.
2. Slide range forward out of installation position to gain
access to components.
3. Disconnect tubing from regulator.
4. Remove screws securing bracket to back of unit.
5. Remove screws securing regulator to support bracket.
6. Reverse procedures to reassemble.
NOTE: When reconnecting supply line to regulator use
pipe dope compound to seal the connection.
NOTE: Perform gas leak test.
Gas Valve
NOTE: Removal of range from installation position is
required.
1. Disconnect power before servicing.
2. Remove range from installation position, see "Move
and/or Replacing Range" procedure.
3. Remove screws securing bottom rear access panel to
chassis.
4. Remove screws securing top rear access panel to
chassis.
5. Disconnect tubing from gas valve.
6. Disconnect and label wire terminals from gas valve.
7. Remove screws securing gas valve to chassis.
8. Reverse procedures to reassemble.
NOTE: Perform gas leak test.
Door Plunger
NOTE: Removal of range from installation position is
required.
1. Disconnect power before servicing.
2. Remove range from installation position, see "Move
and/or Replacing Range" procedure.
3. Remove maintop, see "Maintop Removal" procedure.
(Perform steps 1 – 6.)
4. Remove right side panel, see "Side Panel" procedure.
5. Disconnect and label wire terminals from door plunger
switch.
6. Open oven door and remove screws securing door
plunger to the front of the oven cavity.
7. Reverse procedures to reassemble.
Spark Module
NOTE: Removal of range from installation position is
required.
1. Disconnect power before servicing.
2. Remove range from installation position, see "Move
and/or Replacing Range" procedure.
3. Remove screws securing bottom rear access panel to
chassis.
4. Remove screws securing top rear access panel to
chassis.
5. Label and disconnect wire terminals from spark
module.
6. Remove spark module from secured position.
7. Reverse procedures to reassemble.
Convection Assembly
(Model MGR6875AD*)
1. Disconnect power before servicing.
2. Remove oven door, see "Oven Door(s)-Door Removal"
procedure.
3. Remove oven racks from oven cavity.
4. From inside the oven cavity (center-rear), remove
screws securing assembly shroud or ring-cover.
5. Remove screws securing assembly to cavity.
6. Remove by gently rotating assembly until enough
clearance is established between assembly, cavity
wall and wire terminals/connectors.
7. Disconnect and label wire terminals from heat
element and assembly (connector block).
8. Remove assembly from cavity.
9. Reverse procedures to reassemble.