Filter
Top Products
Activating Con@ctivity 2.0
35
Activating the hob
While t
he cooker hood is searching
for a signal, start activating the hob.
More information about this can be
found in the operating instructions for
the hob.
When connection has been established,
2 and 3 will light up constantly on the
coo
ker hood.
Co
nfirm activation of the cooker
hood with the run-on option control
515. All indicators will go out.
Confirm activation of the hob.
Con@ctivity 2.0 is now ready to use.
If you do not confirm your selection
within 4 min
utes, activation will not take
place.
Activation check
To check whether Con@ctivity 2.0 has
been activat
ed for the cooker hood:
Switch off the fan and hob lighting.
T
ouch the run-on option control
for approx. 10 seconds, until 1 lights
up in the power level display.
Then t
ouch in turn,
– the 1 co
ntrol,
– then the IS co
ntrol,
– then the lighting control .
If Con@ctivity 2.0 has been activated,
the indica
tors for levels 2 and 3 will be
lit up constantly.
If Con@ctivity 2.0 has not been
activat
ed, the indicators for levels 2 and
3 will flash at the same time.
T
o come out of checking mode,
touch the run-on option control .
All indicators will go out.
T
o check whether Con@ctivity has
been activated on the hob, see the
operating instructions for the hob.
If connection cannot be established
despit
e activating the Con@ctivity
function on the cooker hood and
hob, the function must be
deactivated on both appliances and
then the procedure repeated.