Filter
Top Products
Programme sequence
indicator lights (15)
After a programme has been started
the current stage of the programme is
indicated by the programme sequence
indicator lights.
Time display (14)
The running time of the programme se
-
lected shows in hours and minutes in
the time display before a programme is
started. During a programme the time
left until the end of the programme is
displayed. The “Time left” indicator light
next to the time display lights up.
The time displayed in the time display
may vary with the same programme.
This is partly because of the water inlet
temperature at each intake and partly
because of the amount and soiling level
of the crockery.
When the dishwasher is first switched
on the display shows an average time
value for a cold water intake.
Values shown in the programme chart
refer to standard test loads and temper
-
atures.
Each time a programme is run the elec
-
tronic unit takes into account the new
conditions and calculates the time re
-
quired. This new figure is then dis
-
played when this programme is next
selected.
Light ring (17)
The light ring will come on when you
switch the dishwasher on and will go
out at the end of a programme. It will
come on again if the programme selec
-
tor is turned to "Stop" or the door is
opened and then closed again.
If the “Delay Start” function is activated
the light ring will go out 10 minutes after
you have set the delay start time.
If one of the buttons on the control
panel is pressed or the programme se
-
lector is turned during the delay start
period the light ring will come on again
for 10 minutes.
Operation
33