Miele G 1182 Dishwasher User Manual

Waterproof system
All Miele dishwashers have a safety
valve located on the incoming water
line and a sealed underside with a
water sensor. If a fault occurs, the water
intake is stopped and the drain pump is
Connection to the water
Do not drink water from the
The dishwasher can heat its own
water to the temperature required by
the wash program. This allows for
connection of the machine to either a
hot or cold water source. For lowest
energy consumption connect the
dishwasher to a cold water source.
For fastest possible wash times, with
slightly higher energy consumption,
connect the dishwasher to a hot
water source. All programs use hot
water in the rinse cycles.
The inlet hose is approximately 5 ft.
(1.5m) long.
A 5 ft. (1.5m) drain extension is
available from Miele.
The water inlet hose comes
equipped with a 3/4" female hose
thread connector. This can be
directly connected to a water supply
with 3/4" MHT (male hose thread
Water pressure: Must be between
4.5 - 145 psi (0.3 - 10 bar).
To prevent damage to the
dishwasher, it must only be
connected to a fully vented drainage
Do not cut the intake hose. It
contains electrical wiring. If the hose
is cut, the dishwasher will not work.
There will be a water leak and you
could be injured. If the hose is too
long, coil it neatly and place it
behind the machine.