Miele G 698 Dishwasher User Manual


 
3.Building the dishwasher
into a niche
Connection to water and drainage
should be sited beside and not behind
the dishwasher for accessibility.
Connections are usually made in the
area under the sink. Many kitchen unit
manufacturers provide a cut-out in the
base of the sink base unit for the hoses
to be fed through.
If the base unit has no opening and if
there is not an opening through the
plinth area for connections, one must
be cut.
Dimensions: 60 x 110 mm.
,
There must be no electrical
sockets behind the dishwasher.
Danger of overheating and fire risk if
the dishwasher were to be pushed
up against a plug.
Dishwasher height
^
Adjust the height manually before
installing the dishwasher.
Leave a space of approx. 5 mm
below the worktop to allow the
dishwasher to be pushed back easily
into the recess. Make sure that the
dishwasher stands level.
It is easier to adjust the screw feet if the
weight of the dishwasher is not bearing
down on them.
If possible tip the machine slightly.
Slides
You will find the slides in the upper
basket of the dishwasher.
They make installation of the
dishwasher easier and protect the floor
from possible damage when moving
the appliance into and out of the
recess. They are also used for
adjusting the height of the rear screw
feet.
^
Fit the slides - with the ratchet at the
rear - under the screw feet.
Installing integrated "i" Dishwashers
10