Filter
Top Products
DOS 1 (liquid detergent)
Setting the detergent dosage
The dosage concentration only needs to be set for liquid detergents. Set the
concentration according to the detergent manufacturer's recommendations.
Do not change the setting if you are using powdered detergent in the door
dispenser.
Step Display / Result
^
Press the 0 button until E02 appears in
the display.
E02
^
Turn the program selector to
"Inorganica".
Using door dispenser
Using DOS module
10 = 10 sec dosage length
1.00 = 1.0 % dosage concentration
^ Press or hold down the ß button until
the required value appears in the
display, e.g., 0.5.
0.50 The dosage time / dosage
concentration is now set.
Dosage concentration setting:
Priming the dosage system
The dosage system does not need to be primed (cleared of air) unless:
– the dosage concentration is being set for the first time,
– the liquid detergent container was inadvertently completely emptied .
Step Display / Result
^
Press the 0 button until E02 appears
in the display.
E02
^
Turn the program selector to "Custom".
d§1
^
Press the ß button.
The dosage system will be primed
automatically. Priming is complete
when 0 appears in the display.
^
Exit the programming mode.
Start "Rinse" program.
This will rinse away any agents that
entered the wash cabinet during
priming.
Programming functions
37