Filter
Top Products
,
All electrical work must be
carried out by a suitably qualified
electrician in accordance with local
and national safety regulations.
–
Connection should be made via a
suitable isolator, with an on-off switch
that is easily accessible for servicing
work.
–
The electrical connection is made
through a receptacle according to
national requirements. The
receptacle has to be easily
accessible after installation.
– To increase the security it is
recommended to install a protective
switch (30 mA) before the machine.
– For technical data see the data plate
or wiring diagram supplied.
The machine must only be operated
with the voltage, frequency and fusing
shown on the data plate.
The machine can be converted
according to the supplied converting
diagram and wiring diagram.
The data plate is located at the rear of
the machine and behind the plinth on
the plastic cover.
The wiring diagram is supplied with the
machine.
See also the supplied installation
diagram.
A damaged power cord must only
be replaced with a genuine Miele
cord by a Miele service technician.
WARNING
THIS APPLIANCE MUST BE
GROUNDED
Grounding connection
^
The ground lead must be connected
to the screw connection point
(marked with the ground symbol 8) at
the back of the machine.
The machine must only be operated
with the voltage, frequency and
fusing shown on the data plate
located on the rear of the machine,
and on the plinth (behind the service
panel).
The conversion diagram and the wiring
diagram is secured to the inner side of
the service panel.
Electrical connection
68