Filter
Top Products
Timer - use
Programming hob zone cooking
times
Please note it is not possible to use this
programme for hobs which have the
KSE 200 control unit.
A symbol in the display shows which
hob zone is being programmed.
* = front left zone
# = front right zone
t = both front zones
Make sure the correct symbol is show-
ing in the display before programming
in times.
Turn the hob zone control to the set-
ting required.
The corresponding symbol will flash for
a short time.
Enter the times for the automatic pro-
cess (see the relevant Section
below).
When a cooking process has been pre-
selected the hob zone symbol flashes,
and the time of day is displayed. The
hob control light goes out.
When the process starts running, the
symbol for the chosen hob zone lights
up.
When the end of cooking time is
reached
– the hob switches off automatically,
– an audible tone sounds for approx. 5
seconds.
– The symbol for the selected hob
zone and the symbol “)” flash. The
symbol “)” does not flash when a
cooking end time is entered for the
oven.
If the audible tone is not switched off,
as described earlier, it will repeat at 5
minute intervals as a reminder that the
end time has been reached. This re-
minder continues for up to an hour.
Both the audible tone and the visual
display can be cancelled by:
– Pressing the “)” button.
To use the oven again, the hob zone
selector switch must first of all be
turned to “0”.
– Turning the hob zone selector
switch to “0”.
29