Filter
Top Products
Cleaning and care
Cleaning catalytic enamel using the
extra cleaning process
Before carrying out the extra cleaning
process, take out the rack and runners,
or telescopic frame remove any soiling
from the “Clean-Enamel” areas.
To operate the extra cleaning process:
Turn the oven function selector to
“Fan Heat D”.
With the + button select the highest
temperature setting.
Let the oven operate for about one
hour. The length of time will depend on
the degree of soiling. It is a good idea
to set the finish time for the process
using the timer. This way you will not
forget to switch the oven off at the end.
Wipe over all the visible surfaces which
are not protected by the catalytic
liners, especially the oven floor.
Every time the oven is used at high tem-
peratures any remaining soiling will
gradually disappear.
Should the catalytic coating on the
back panel or any other catalytic pa-
nels fitted become ineffective
through improper use or heavy soil-
ing, for example, a replacement can
be obtained from your Miele dealer
or Miele Spare Parts dept.
54