Filter
Top Products
Oven interior
The oven interior, back panel and roof liner are coated with
dark pyrolytic enamel which facilitates cleaning.
This is a particularly hard enamel with an extremely smooth
surface.
Because of its anti-stick properties most debris can be easily
removed with warm water and a little washing-up liquid
applied with a soft cloth. This should be done after each use.
Allow the oven to cool down before cleaning.
Danger of burning!
Never use hard brushes, hard sponges, wire wool pads*,
knives or any other abrasive materials or cleaning agents.
They can damage the enamel.
If using an oven spray, the manufacturer's instructions
must be followed.
* Non-abrasive stainless steel spiral pads can be used.
Pyrolytic cleaning of the oven interior
Before starting a pyrolytic cleaning process please note the
following advice:
Remove any coarse soiling from the oven before you start.
Clean the interior glass door panel thoroughly. Otherwise
splashes on the door may burn on making them difficult to
remove.
There is a fibre-glass door seal around the oven cavity.
This seal is particularly sensitive and should not be
cleaned unless absolutely necessary. Rubbing the seal
can damage it.
Cleaning and care
56