Filter
Top Products
The temperature is adjustable in steps
from -5 to +5 and is displayed in the
freezer section temperature display.
Each step represents a change in
temperature of approx. 0.5 to 1 °C. If
there is a "-" in front of the figure, the
temperature has been lowered by this
amount.
^
Press the alarm button briefly.
The new temperature has now been
stored in the appliance’s memory.
The appliance will automatically
return to normal operation after
approx. 5 minutes, if you do not
press any buttons whilst in setting
mode.
Temperature displays
During normal operation the
temperature display on the control
panel shows the temperature in the
middle of the refrigerator section and
the temperature in the warmest part of
the freezer section.
If the temperature in the appliance is
not within the range that the appliance
is able to display (i.e. if it is not between
0 °C and 19 °C in the refrigerator
section, and if the temperature in the
freezer section is above 0 °C), then only
a bar will light up in the temperature
displays.
The temperature displays flash, if
–
a different temperature is being set,
–
the temperature in the appliance has
risen by several degrees, indicating
that the appliance is warming up too
much.
This loss of coldness is no cause for
concern in the following circumstances:
–
when the door has been left open for
a while, e.g. for removing or storing a
large amount of food,
–
when fresh food is being frozen.
However, if the temperature remains
above -18 °C for a long time, check that
the frozen food has not started to
defrost. If this is the case, check that
the food is safe to use and if it is, then
use it as soon as possible.
Temperature display brightness
The appliance is supplied with the
brightness of the temperature display
set as low as possible. However, if the
door is opened, a setting changed or if
the alarm is sounding, the temperature
display will appear much brighter for
approx. 1 minute.
The level of brightness can be adjusted
to be:
–
Brighter: by pressing the alarm
button, and whilst holding it in press
the upper button next to the
temperature display for the freezer
section.
–
Dimmer: by pressing the alarm
button, and whilst holding it in press
the lower button next to the
temperature display for the freezer
section.
The correct temperature
16