Miele KF 7540 SN Freezer User Manual


 
Repairs to electrical appliances
should only be carried out by a
suitably qualified and competent
person in accordance with local and
national safety regulations. Repairs
and other work by unqualified
persons could be dangerous. The
manufacturer cannot be held liable
for unauthorised work.
The following can be corrected without
contacting the Miele Service
Department:
What to do if . . .
. . . strange noises can be heard after
switching on the appliance,
especially after it has just been
installed.
^ Check to see whether any pieces of
furniture next to the appliance are
vibrating whilst the appliance is in
operation.
Switch the appliance off then:
^
Check whether the appliance is
aligned correctly.
^
Check whether all parts at the rear of
the appliance are free from
hindrance. Remove any hindrance.
^
Check whether the cable clips were
unclipped from the back of the
appliance before installation. They
could vibrate when the appliance is
operating.
^
Are all removable parts securely
located in the appliance?
^
Are any bottles or containers
unstable or knocking against each
other?
Remember that the noise of the
compressor and the coolant circulating
in the system is unavoidable.
. . . the appliance refrigerator or
freezer section does not get cool.
^
Check whether the respective section
is switched on. The relevant
temperature display must be lit up.
^
Check that the plug is correctly
inserted in the socket.
^ Check that the fuse is not defective
and that the mains fuse has not
blown. If it has, consult the Miele Ser-
vice department.
. . . the door to the freezer section will
not open because it has been opened
and closed too many times in
succession.
This is not a fault. The suction caused
by opening and closing the door is
preventing the door from opening. Wait
a few minutes and then try again. It
should now open without force.
. . . the temperature in the refrigerator
section or freezer section is too low.
^
Select a warmer temperature.
^
The super freeze or super cool
function has not been switched off.
The respective indicator light is still
on.
Problem solving guide
33