Filter
Top Products
The appliance can be installed in a
kitchen run. To match the height of the
rest of the kitchen, the appliance can
be fitted with a suitable top box a.
A ventilation gap of at least 50 mm
depth must be allowed for behind the
appliance for air to circulate.
The cross section of the air outlet under
the room ceiling must be at least
300 cm
2
to ensure that air can circulate
without hindrance. Otherwise the
appliance has to work too hard
resulting in an increase in electricity
consumption. The larger the cross
section, the more efficient the
appliance.
The air inlet and outlet must not be
covered or blocked in any way.
They should be dusted on a regular
basis.
When built into a kitchen run (max.
depth 580 mm) the appliance can be
installed directly next to a kitchen
furniture housing unit. The appliance
door b will protrude in front of furniture
fronts at the sides by 34 mm and by 51
mm in the middle of the door. This will
allow the doors to be opened and shut
without being obstructed.
When installed next to a wall c a gap
of approx. 36 mm is needed on the
hinge side between the wall and the
appliance, so that the doors and the
handles have sufficient space for
opening.
When securing to adjoining furniture
d or if a spacer bar is fitted between
the appliance and the wall, please note
the following:
^
Ensure that the doors have sufficient
space for opening fully after the
appliance has been secured.
^
Do not drill within the area marked
with criss cross pattern as this
would damage insulated parts of the
appliance.
^
To secure the appliance to adjoining
kitchen furniture use self-tapping
screws. The depth of the screw must
not exceed 10 mm. See small
illustration.
Building in the appliance
44