Filter
Top Products
^
Using flat-nosed pliers, carefully pull
the insert out together with the entire
cable loop.
Do not pull on the cable to remove
the insert - you could damage it!
^
Remove the stoppers and replace
them on the opposite side.
^
Replace the cable loop and insert on
the opposite side.
^
Screw the insert securely into
position.
^
Fit the covers back onto both sides.
Cover A (marked on the underside of
the cover) goes on the side with the
cable, Cover B on the other side!
^
Push the bearing bushing securely
into position until there is almost no
gap between it and the top of the
door.
Refitting the appliance doors:
^
Fit the stoppers into the top of the
freezer section door.
^ Hang the lower door on hinge pin j
and then close the appliance door.
^ Fit lower hinge bracket b in the door
bearing bushing of the lower door.
Then screw it securely to the
housing.
^
Refit cover a.
^
Fit the top appliance door onto
middle hinge pin j.
^
Open the door.
Changing the door hinging
53