Filter
Top Products
Solid wood and tiled worktops
a Worktop
b Hob
c Gap
d Wooden frame 7 mm
(to be provided on site)
As the ceramic glass and the
worktop cut-out have a certain
dimensional tolerance, the size of
gap c can vary.
^
Make the worktop cut-out as shown
in "Building-in dimensions".
Remember to maintain the minimum
safety distances (see "Safety
instructions for installation").
^
Fix the wooden frame d 2mm
below the top edge of the worktop
(see diagram).
^
Feed the connection cable down
through the cut-out.
^
Centre the hob b in the cut-out.
^
Connect the hob to the mains (see
"Electrical connection").
^ Connect the appliance to the gas
supply (see "Gas connection").
^ Secure the appliance at the back and
front using the fixings supplied. See
"Securing the appliance".
^ Check that the hob works.
^ Seal the remaining gap c with a
silicone sealant that is heat-resistant
to at least 160 °C.
Please follow the manufacturer's
instructions.
For granite and marble tiles only
use a silicone sealant that is
specifically formulated for granite
and marble, and observe the sealant
manufacturer's instructions.
KM 2357
42