Filter
Top Products
Before connecting the appliance,
ensure that it has not been damaged
in any way. Do not use a damaged
appliance.
Electrical connection U.K.
All electrical work should be carried out
by a suitably qualified and competent
person in strict accordance with na
-
tional and local safety regulations.
The appliance is supplied with a cable
and moulded plug ready for connection
to a 230-240 V/50 Hz a.c. single phase
supply.
The voltage, rated load and fusing are
given on the data plate which is located
externally on the rear wall of the appli-
ance. Please ensure that these match
the household mains supply.
Connection should be made via a fused
connection unit or a fused plug and a
suitable switched socket, or via a suit-
able isolator, which complies with na
-
tional and local safety regulations, and
the on/off switch should be easily ac
-
cessible after the appliance has been
installed.
If the socket is not accessible after in
-
stallation (depending on country) an
additional means of disconnection must
be provided for all poles.
When switched off there must be an
all-pole gap of 3 mm in the isolator
switch (including switch, fuses and re
-
lays acc. to EN 60335).
For extra safety it is advisable to install
a residual current device with a trip cur
-
rent of 30 mA (in accordance with DIN
VDE 0664, VDE 0100 Section 739).
If the appliance is connected via an iso
-
lator switch the plug must be cut off
and rendered useless.
Important
The wires in the mains lead of this ap
-
pliance are coloured in accordance
with the following code:
Green/yellow = Earth
Blue = Neutral
Brown = Live
As the colours of the wires in the mains
lead of this appliance may not corre-
spond with the markings identifying the
terminals in your plug, proceed as fol-
lows:
The wire coloured green and yellow
must be connected to the terminal in
the plug which is marked with the letter
E or by the earth symbol z or coloured
green or green and yellow.
The wire coloured blue must be con
-
nected to the terminal marked with the
letter "N" or coloured black. The wire
coloured brown must be connected to
the terminal marked with the letter "L" or
coloured red.
WARNING
THIS APPLIANCE MUST BE
EARTHED
Electrical connection
38