Filter
Top Products
Before connecting the appliance,
ensure that it has not been
damaged in any way. Do not use a
damaged appliance.
Electrical connection U.K.
All electrical work should be carried out
by a suitably qualified and competent
person in strict accordance with current
national and local safety regulations
(BS 7671 in the UK).
The appliance is supplied with a mains
cable and moulded plug ready for
connection to an a.c. single phase
220-240 V 50 Hz supply.
The voltage and connected load are
given on the data plate which is located
inside the door to the appliance. Please
ensure that these match the household
mains supply. The fuse rating is quoted
on the plug.
Connection should be made via a fused
connection unit or a fused plug and a
suitable switched socket, or via a
suitable isolator, which complies with
national and local safety regulations,
and the on/off switch should be easily
accessible after the appliance has
been installed. If it is installed via an
isolator switch, connection must be
carried out by an electrician.
When switched off there must be an
all-pole gap of 3 mm in the isolator
switch (including switch, fuses and
relays acc. to EN 60335).
If the switch is not accessible after
installation (depending on country) an
additional means of disconnection must
be provided for all poles.
For extra safety it is advisable to protect
the appliance with a residual current
device. Please contact a qualified
electrician for advice.
WARNING
THIS APPLIANCE MUST BE
EARTHED
Non-rewireable plugs BS 1363
The fuse cover must be re-fitted when
changing the fuse, and if the fuse cover
is lost the plug must not be used until a
suitable replacement is obtained. The
colour of the correct replacement cover
is that of the coloured insert in the base
of the plug, or the colour that is
embossed in words on the base of the
plug, (as applicable to the design of
plug fitted).
Replacement fuses should be ASTA
approved to BS 1362 and have the
correct rating. Replacement fuses and
fuse covers can be purchased from
your local electrical supplier.
If the connection cable is damaged
it must be replaced by a Miele
approved Service Technician only.
This appliance conforms with European
Standard EN 55011 as a Group 2,
Class B product. Group 2 appliances
use high frequency energy in the form
of electro-magnetic waves to create
heat in food. Class B is assigned to
appliances that are suitable for
domestic use.
Electrical connection
67