Filter
Top Products
10
Once you have selected
programme 12 from the MENU:
a) Touch the HOMEMADE button
once, KNEAD 1 will appear on the
LCD display, then touch the TIME
button to adjust the minutes, and
then touch the HOMEMADE button
to confirm the time for this step.
b) Touch the HOMEMADE button to
enter the next step, RISE 1 will
appear on LCD display, then touch
the TIME button to adjust minutes,
the number will increase quickly
once you hold the TIME button. The
time will only increase in minutes. To
decrease the amount of minutes,
touch the TIME button until you
reach the MAX time, then touch the
TIME button again to return to “0”.
You can then touch the TIME button
to increase to the required time.
Touch the HOMEMADE button to
confirm the time for this step.
c) Following the same method as for
the KNEAD 1 and RISE 1, set the
remaining steps. Upon finishing
setting all; the steps, touch the
START/STOP button to exit the
setting.
d) Touch Start/stop button again to
activate the operation.
NOTE: The setting can be
memorised and ready for the next
time you use the breadmaker.
Start/stop
For starting and stopping the
selected baking programme.
To start a programme, touch the
START/STOP button once. A short
beep will be heard and the two dots
in the time display begin to flash and
programme starts. Any other button
is inactivated except the
START/STOP, LIGHT and PAUSE
buttons after a programme has
switched off. This feature will help to
prevent any unintentional disruption
to the operation of programme.
To stop the programme, touch the
START/STOP button for 2 seconds,
a beep will sound to confirm.
Time
Use the timer when you want the
bread to be ready later or in the
morning. A maximum of 13 hours
can be set. Check if this function is
available by looking at “Baking cycle
times’ on page 30 for further
instructions.
Pause
After the baking cycle starts, you
can touch the PAUSE button to
interrupt the process at any time.
The operation will be paused but
the setting will be memorised, the
outstanding time will be flashed on
the LCD. Touch the PAUSE button
again and the programme will
continue.
Memory
If the power supply has been
interrupted during the course of
making bread, the process of
making bread will be continued
automatically within 10 minutes,
without touching the STOP/START
button . If the interruption time
exceeds 10 minutes, the memory
cannot be kept, you must discard
the ingredients into the baking pan
and add the ingredients into the
baking pan again, and the
breadmaker must be restarted. But
if the dough has not entered the
rising phase when the power supply
breaks off, you can’t touch the
START/STOP button directly to
continue the programme from the
beginning.
Keep warm
Bread can be automatically kept
warm for 1 hour after baking. Hot air
will be circulated to keep it warm.
The function can be used on most
settings (See ‘Baking cycle times’
section). During keeping warm, if
you would like to take the bread out,
switch the programme off by
touching the START/STOP button
.
BM48271 Rev2 18/7/07 16:32 Page 10