Mr. Coffee ECM20 Espresso Maker User Manual


 
1312 13
PROBLEM S AND
CAUSES
PROBLEM C
AUSES SOLUTIONS
Add water
Grind coffee medium ground
Fill filter only to 4 cup mark
Tighten cap
Plug unit into electrical outlet.
Turn on
Refill filter basket with coffee.
DO NOT TAMP
Rotate filter holder to full lock
Wipe off rim; fill only to 4 cup
mark
Fill only to 4 cup mark
Fill reservoir with correct amount
of water. See Page 7
Empty some water from reservoir.
See Page 8
Turn on unit with control knob
Following frothing stage, operate
frothing function for 1– 2 seconds
to extract excess milk. Or, turn off
unit, allow unit to cool, unplug unit
and clean out frothing tube with
a needle or toothpick.
Pour in the required amount
of water to make cappuccino.
See Page 8
Chill milk and frothing pitcher
prior to making cappuccino
Use a finer grind
Use more coffee
Once unit has cooled, use more
water to brew espresso
Coffee does
not come out
Coffee comes
out around
the edge of the
filter holder
No steam is
generated
Milk is not
foamy after
frothing
Coffee comes
out too quickly
Coffee is
splattering out
of frothing tube
No water in reservoir
Coffee grind is too fine
Too much coffee in the filter
Cap is not secure, steam is escaping
Appliance was not turned on
or plugged in
Coffee has been tamped /
compressed too much
Filter holder not rotated
to full lock position
Coffee grounds around the filter
basket rim
Too much coffee in the filter basket
Water reservoir is empty
Too much water in the reservoir –
no room for steam
Appliance is not turned on
Frothing tube is blocked
Ran out of steam
Milk is not cold enough
Ground coffee is too coarse
Not enough coffee in filter basket
Water tank is empty or low,
not enough pressure
12
3. Allow appliance to sit overnight with the vinegar solution in the water reservoir.
4. Discard vinegar through the top opening of the Espresso Maker by turning the machine
upside down over the sink.
5. Rinse the water reservoir thoroughly with tap water by filling tank half full with water
and then pouring the water back out into the sink, repeating this step twice.
TO D
ELIME INTERNAL PARTS:
1. Make sure you delime the inside of the water reservoir first by following the “Deliming” steps
above.
2. Make sure all controls are “OFF,” the power cord is disconnected from the electrical outlet,
the appliance is cool and all pressure in the appliance has been released.
(See Section
“CAUTION:P
RESSURE
on Page 6).
Fill carafe to the top of the metal band with vinegar
and pour into reservoir.
3. Screw the cap back on top of the water reservoir. Make sure the cap is on tight.
4. Insert the brew basket (with filter) and place the glass carafe with lid on the drip tray.
5. Plug the power cord into the electrical outlet.
6. Turn the control knob to the position. When vinegar begins to flow into the carafe, place
a cup with cold water under the frothing aid. Insert the frothing tube into the water and slowly
turn the control knob to the position. After ten seconds turn the control knob to the “OFF”
position. This will clean any residue left in the frothing tube from frothing milk.
7. Turn the control knob to the position. When all the vinegar has been pumped into the carafe
and the flow has stopped, turn the control knob to “OFF” and allow the appliance to cool.
8. Repeat Steps 1 – 7 using only tap water to rinse any remaining traces of vinegar out of the
machine. Repeat this rinsing process, allowing the machine to cool and pressure to be released
before each rinsing.
CARAFE CLEANING
Hard water can leave a whitish mineral deposit inside the carafe. Coffee discolors these deposits,
sometimes leaving a brownish stain inside the carafe. To remove these stains, follow these
simple steps:
1. Use a solution of equal parts white vinegar and hot water.
2. Let solution stand in carafe for about 20 minutes and then discard.
3. Wash and rinse the carafe thoroughly using a soft cloth. Do not use harsh abrasive cleaners.
These may cause scratches which can lead to breakage.