Filter
Top Products
3.
Make sure the filter retainer clip is in the release position, by pulling
the clip back toward your hand. Place the filter holder underneath the
brew head so that the handle is positioned to the left of center. Lift the
filter holder up and insert into the brew
head. Turn the handle completely to the
FIGURE 2
right until it stops just to the right of cen-
ter. The holder is now secured in the
machine. See figure 2.
Brewing Espresso...
ATTENTION: PLEASE REFER TO THE
NEXT SECTION TO MAKE
CAPPUCCINO.
1.
2.
3.
4.
5.
6.
7.
8.
Make sure the drip tray is in place.
Place the cover on the glass decanter
and set in place on drip tray.
Make sure the steam control knob is in
the center off position.
Plug the power cord into an electrical
outlet and rotate the selector knob
upward to the coffee
symbol.The
switch
will illuminate to let you know the
machine is on. See figure 3.
Espresso will begin to flow into the decanter in about four minutes.
When the espresso has stopped flowing into the decanter, turn the power
switch off back at the center. Unplug the power cord and allow the
machine to cool.
Do not remove pressure cap until the pressure in the
machine has been released. See section “CAUTION-PRESSURE”.
After the machine has cooled down and all pressure has been
relieved, remove the filter holder from the brew head. Using the filter
retainer clip to secure the filter basket in the filter holder, turn the filter
holder upside down to empty. Rinse the filter basket and holder with
water.
CAUTION:
The metal parts of the filter holder might still be very hot.
Make sure to use the filter retainer clip when discarding the grounds.
Cool down these parts by running under cold water.
See instructions for cleaning on page 10.
7