Palsonic PMO-585 Microwave Oven User Manual


 
INSTALLATION
BEFORE INSTALLING THE OVEN
Make sure that the oven door closes correctly and that the seal is not damaged.
PLACE
Take account of the following recommendations when installing the microwave:
1. Keep it away from heat sources (e.g. oven). Heat affects correct appliance
operation.
2. Keep a distance of about 3 cm between the wall and the back part.
Allow a minimum space of 3 cm between the microwave top and the unit,
if the appliance is to be installed below a unit.
Taking account of these recommendations guarantees suitable ventilation.
3. Place the microwave on a flat and stable surface that is strong enough to hold the oven and the
additional weight (food-utensils). Remember that the control panel side is
the heavy side.
4. The oven ventilation openings must NOT be covered. Blocking the
ventilation or the openings may affect correct oven operation and
give poor cooking results.
5. Install the oven at least 2 m from radio, television or aerial to avoid
interference.
ELECTRICAL INSTALLATION
Before connecting the microwave oven
-
Check that the electrical supply voltage is correct.
-
Have a socket with earth discharge suitable for the product’s power.
-
Use protective fuses for the line.
Do NOT Change the plug for any reason, shortening the mains cord.
Do not use multiple sockets or adapters to make the connection, either.
N. B.:
If you do not have a socket with earth, contact a specialist to make a correct earth connection.
This recommendation is for SAFETY REASONS. UNDER NO CIRCUMSTANCE change the plug,
shortening the mains cord, or use adapters to make the connection.
Important:
All our units are manufactured to the strictest safety standards.
For total user protection THIS APPLIANCE MUST BE
EARTED.
If you do not have a correct earth connection, contact a specialist for its installation. The
manufacturer will accept no responsibility for injury to persons or damage to objects arising
from the non-observance of this requirement, even with the additional protection of a differential
circuit breaker.
2