Filter
Top Products
- 13 -
4
Press Power Level Selector pad four times.
☛ The selected power level will be indicated, “PROG” and 1st Stage
Heating Indicator “1” will start to blink.
1
A
PROG
5
Set the desired heating time using Timer Dial.
☛ The set heating time will appear.
Note:up to 15 min. on or , 60 min. on , or
1
A
PROG
6
Press Program Entry Switch again.
☛ “PROG” and 1st Stage Heating Indicator “1” will stop blinking.
This means that you have completed programming.
PROG
1
A
PROG
• Three seconds later, Digital Display Window will go blank.
Note:
• Program the remaining Memory pads as desired by repeating steps 2-6 above.
• When you want to select Memory Area B, press Memory Shift pad before selecting the desired Memory pad.
AB
3
Press Memory pad you wish to program.
☛ The selected pad number will appear and currently programmed
information will be indicated.
5
1
A
PROG
C. PROGRAMMING MEMORY PADS
◆Single stage heating
INSTRUCTION
DIGITAL DISPLAY WINDOW
PAD
2
Press Program Entry Switch.
☛ “PROG” will start to blink.
PROG
PROG
THE OVEN CAN NOT BE PROGRAMMED WHEN PROGRAM LOCK IS ACTIVATED! (see page 14 - 15)
DO NOT OPEN THE DOOR WHILE PROGRAMMING!
Example: To program cooking at DEFROST power for 1 minute into Memory pad “5”
1
Keep the door closed.
☛ Digital Display Window must be blank or show “0”.
How to Operate NE - 3280/NE - 2180/NE - 1880