Filter
Top Products
- 14 -
D. PROGRAM LOCK
INSTRUCTION
DIGITAL DISPLAY WINDOW
PAD
1
Keep the door closed.
☛ Digital Display Window must be blank.
2
Press Program Lock Switch until “PROG”, “P” and “L” appear.
(for five seconds)
☛ “PROG”, “P” and “L” will appear.
PROG LOCK
PROG
In Program Lock mode:
• The oven is started by pressing the desired Memory pad. There is no need to press Start pad.
• Opening the door cancels the remaining time on the program.
• The oven can not be programmed until the program lock is released.
◆
To Activate Program Lock:
6
Press Power Level Selector pad once.
☛ The power level for 2nd stage will be indicated, 2nd Stage Heating
Indicator “2” will start to blink.
1
A
2
PROG
7
Set the desired heating time using Timer Dial.
☛ The set heating time will appear.
Note:up to 15 min. on or , 60 min. on , or
1
A
2
PROG
8
Press Program Entry Switch again.
☛ “PROG” and 2nd Stage Heating Indicator “2” will stop blinking. The
total time for both stages will appear. This means that you have
completed programming.
PROG
1
A
2
PROG
• Three seconds later, Digital Display Window will go blank.
◆2 or 3 stages heating
INSTRUCTION
DIGITAL DISPLAY WINDOW
PAD
Follow steps 1 to 5 on page 13.
1
A
PROG
Example: To program cooking at DEFROST power for 1 minute and at HIGH power for 2 minutes into Memory pad “5”
THE OVEN CAN NOT BE PROGRAMMED WHEN PROGRAM LOCK IS ACTIVATED! (see page 14 - 15)
DO NOT OPEN THE DOOR WHILE PROGRAMMING!
How to Operate NE - 3280/NE - 2180/NE - 1880