Filter
Top Products
- 15 -
E. BEEP TONE
The loudness of beep tone and the length of beep tone at the end of heating cycle can be set.
There are four levels of the loudness.
There are two options of the length of beep tone at the end of heating cycle.
The loudest level and 3 beeps are preset at the factory.
◆
To Select Loudness Level and Length “3 beeps”:
INSTRUCTION
DIGITAL DISPLAY WINDOW
PAD
1
Press Program Entry Switch.
☛ “PROG” sign will start to blink in the display window. (The door may be
open or closed at this stage)
PROG
PROG
2
Press Buzzer Switch.
☛ The tone will sound at its loudness level and the loudness level “3”
followed by the word “bEEP” will appear. “PROG” will start to blink and
1st Stage Heating Indicator “1” (the length of beep tone “3 beeps”) will
be indicated.
Note: Repeatedly pressing the Buzzer Switch will lower the loudness level
all the way to silent. (3bEEP –– loudest, 2bEEP –– middle,
1bEEP –– quietest, and 0bEEP –– silent)
BUZZ
1
PROG
3
Press Program Entry Switch again.
☛ “PROG” will stop blinking. That means that you have completed
program.
Three seconds later, the display window will go blank when the door is
closed.
1
PROG
PROG
In Program Unlock mode:
• Oven reverts to a two-touch operating mode (Memory pad + Start pad).
• Repeat and interrupt feature are operational.
• Memory pads can be programmed.
• Tone loudness control and length control are operational.
◆
To Release Program Lock:
INSTRUCTION
DIGITAL DISPLAY WINDOW
PAD
1
Keep the door closed.
☛ Digital Display Window must be blank.
2
Press Program Lock Switch until “PROG” and “P” appear.
(for five seconds)
☛ “PROG” and “P ” will appear.
PROG LOCK
PROG
How to Operate NE - 3280/NE - 2180/NE - 1880