Filter
Top Products
- 16 -
G. CYCLE COUNTER
INSTRUCTIONPAD
1
Open the door and leave it open.
☛ The oven lamp will turn on and “0” will appear.
2
Close the door.
☛ Carry out Step 3 within 60 seconds of closing the door, or the display
will go blank.
DIGITAL DISPLAY WINDOW
F. PROGRAM LIST
INSTRUCTION
DIGITAL DISPLAY WINDOW
PAD
1
Open the door and leave it open.
☛ The oven lamp will turn on and “0” will appear.
2
While pressing Stop/Reset pad, press Start pad.
☛ All currently programmed information (the program set into each
Memory pad (A/B sides), Beep Tone, and Program Lock information)
will continuously appear.
+
1
A
PROG
3
While pressing Buzzer Switch, press Program Entry Switch.
☛ The display shows the total cumulative number of times the oven has
been used.
PROG
◆
To Read Total Cumulative Times That The Oven Has Been Used:
BUZZ
+
1
B
PROG
2
INSTRUCTION
DIGITAL DISPLAY WINDOW
PAD
4
Follow step 1-3 on page 15.
1
PROG
5
Within three seconds after pressing Program Entry Switch at step 3,
press Buzzer Switch.
☛ “PROG” will start to blink and 2nd Stage Heating Indicator “2” (the
length of beep tone “short beeps for 60 seconds”) will be indicated.
PROG
2
6
Press Program Entry Switch again.
☛ “PROG” will stop blinking. This means that you have completed
programming.
Three seconds later, the display window will go blank when the door is
closed.
PROG
2
◆
To Select Length of Tone “short beeps for 60 seconds”:
BUZZ
PROG
How to Operate NE - 3280/NE - 2180/NE - 1880